Cisco Cisco Firepower Management Center 4000 Installationsanleitung

After you install Cisco NGIPS for Blue Coat X-Series, you must set up a Cisco Defense Center to 
manage the software. These steps include obtaining the proper licenses, adding Cisco NGIPS for Blue 
Coat X-Series to the Defense Center, and configuring the interfaces.

For more information, see:

Licensing the FireSIGHT System in the FireSIGHT System User Guide

For more information on configuring the FireSIGHT System, including access control policies and so 
on, see the FireSIGHT System User Guide.

You must use a Defense Center to manage Cisco NGIPS for Blue Coat X-Series. You use at least two of 
three fields for configuring communications between appliances:

 — the hostname or IP address

 — the registration key

 — a unique alphanumeric ID (use if a NAT device separates your Cisco 

NGIPS for Blue Coat X-Series installation from the Defense Center)

Valid combinations include:

 and 

 on both the Defense Center and Cisco NGIPS for Blue Coat 

X-Series.

 and 

 on Cisco NGIPS for Blue Coat X-Series with 

 

and 

 on the Defense Center.

Management Host, Registration Key, and Unique NAT ID on Cisco NGIPS for Blue Coat X-Series with 

Registration Key and Unique NAT ID on the Defense Center.

If you are using VAP groups, consider using device groups to parallel your VAP group configuration.

After you add Cisco NGIPS for Blue Coat X-Series to the Defense Center, use the Defense Center to 
configure the interfaces, as described in 

. For more 

information on configuring the FireSIGHT System, see the FireSIGHT System User Guide.