Cisco Cisco IOS Software Release 12.2(55)SE

Seite von 88
 
13
Release Notes for the Catalyst 3750, 3560, 2975, 2960-S, and 2960 Switches, Cisco IOS Release 12.2(55)SE and Later
OL-23054-07
Minimum Cisco IOS Release for Major Features
The IP Base image supports OSPF for routed access to enable customers to extend Layer 3 routing 
capabilities to the access or wiring closet. The IP services image is required if you need multiple 
OSPFv2 and OSPFv3 instances without route restrictions. (Catalyst 3750 and 3560)
MAC move to allow hosts (including the hosts connected to an IP phone) to move across ports within 
the same switch without any restrictions to enable mobility. With MAC move, the switch treats the 
reappearance of the same MAC address on another port as a completely new MAC address.
MAC replace can be configured so that when a host disconnects from a port without ending its 
session, the session can be ended and the authentication sequence reset when a new MAC address 
connects to the port.
Support for increasing the NVRAM buffer size for saving large configuration files. 
ARP tracking probe enhancement to specify a source IP address for a VLAN.
Network Edge Access Topology (NEAT) controls the supplicant port during the supplicant 
authentication period. When you connect a supplicant switch to the authenticator switch, the 
authenticator port could be error-disabled when receiving Spanning Tree Protocol (STP) bridge 
protocol data unit  (BPDU) packets and the supplicant switch is not authenticated. The NEAT feature 
is now enhanced to block the supplicant port during authentication, to ensure authentication 
completes. 
Use the dot1x supplicant controlled transient global configuration command to control access to 
the supplicant port during authentication. Use the no form of this command to provide access to the 
supplicant port during the authentication period.
CISCO-ENERGYWISE-MIB enhancements. See the Release Notes for Cisco EnergyWise, 
EnergyWise Phase 2
 for information. (Catalyst 3750, 3560, 2960-S, and 2960)
Minimum Cisco IOS Release for Major Features
 lists the minimum software release required to support the major features of the Catalyst 3750, 3560, 
2975, 2960-S and 2960 switches and the Cisco EtherSwitch service modules.
Table 7
Catalyst 3750 and 3560, 2975, 2960-S and 2960 Switches and Cisco EtherSwitch Service Module Features 
and the Minimum Cisco IOS Release Required
Feature
Minimum Cisco 
IOS Release 
Required
Catalyst Switch Support
Auto-QoS enhancements
12.2(55)SE
3750, 3560,2975, 2960, 2960-S 
Auto Smartport enhancements including global macros 
12.2(55)SE
3750, 3560,2975, 2960, 2960-S 
Smart Install enhancements and new features
12.2(55)SE
3750, 3560,2975, 2960, 2960-S 
Port ACL improvements
12.2(55)SE
3750, 3560,2975, 2960, 2960-S 
CDP and LLDP location enhancements
12.2(55)SE
3750, 3560,2975, 2960, 2960-S 
Multi-authentication with VLAN assignment
12.2(55)SE
3750, 3560,2975, 2960, 2960-S 
Cisco TrustSec 
12.2(55)SE
3750 and 3560 
Memory-consistency check routines
12.2(55)SE
3750, 3560, 2975, 2960
Static routing support on SVIs
12.2(55)SE
2975, 2960, and 2960-S
MAC replace to end a sesssion when a host disconnects from a port. 12.2(55)SE
3750, 3560,2975, 2960, 2960-S