Cisco Cisco IPS 4255 Sensor
18
Release Notes for Cisco Intrusion Prevention System 7.0(8)E4
OL-26888-01
After Upgrading to Cisco IPS 7.0(8)E4
For More Information
•
For the procedure for locating software on Cisco.com, see
•
For a list of the specific software filenames, see
.
•
For the procedure for enabling and disabling heartbeat reset on the AIM IPS and the NME IPS, refer
to
to
•
For the procedure for reimaging sensors, refer to
•
For the procedure for configuring automatic updates, for the CLI refer to
for the IDM refer to
the IME refer to
.
•
For the procedure for disabling global correlation, for the CLI refer to
, and for the IME refer to
.
•
For the procedure for omitting global correlation from the overall sensor health status, for the CLI
refer to
refer to
for the IME refer to
.
After Upgrading to Cisco IPS 7.0(8)E4
This section provides information about what to do after you install IPS 7.0(8)E4. It contains the
following topics:
following topics:
•
•
•
•
Comparing Configurations
Compare your backed up and saved previous IPS configuration with the output of the show
configuration command after upgrading to 7.0(8)E4 to verify that all the configuration has been
properly converted.
configuration command after upgrading to 7.0(8)E4 to verify that all the configuration has been
properly converted.
Caution
If the configuration is not properly converted, check the caveats for IPS 7.0(8)E4 or check Cisco.com
for any upgrade issues that have been found. Contact the TAC if no DDTS refers to your situation.
for any upgrade issues that have been found. Contact the TAC if no DDTS refers to your situation.
For More Information
For a list of the caveats associated with this release, see
.