Cisco Cisco IPS 4255 Sensor

For the procedure for locating software on Cisco.com, see 

For a list of the specific software filenames, see 

.

For the procedure for enabling and disabling heartbeat reset on the AIM IPS and the NME IPS, refer 
to 

For the procedure for reimaging sensors, refer to 

For the procedure for configuring automatic updates, for the CLI refer to 

for the IDM refer to 

 

the IME refer to 

.

For the procedure for disabling global correlation, for the CLI refer to 

, for the IDM refer to 

, and for the IME refer to 

.

For the procedure for omitting global correlation from the overall sensor health status, for the CLI 
refer to 

, for the IDM refer to

for the IME refer to

.

This section provides information about what to do after you install IPS 7.0(8)E4. It contains the 
following topics:

Compare your backed up and saved previous IPS configuration with the output of the show 
configuration command after upgrading to 7.0(8)E4 to verify that all the configuration has been 
properly converted.

If the configuration is not properly converted, check the caveats for IPS 7.0(8)E4 or check Cisco.com 
for any upgrade issues that have been found. Contact the TAC if no DDTS refers to your situation.

For a list of the caveats associated with this release, see 

.