Cisco Compact Mini Amp Models 93191 & 93198 862 MHz with 42 54 MHz Split Installationsanleitung
2-14
Installing and Configuring the GainMaker Line Extender
593057 Rev E
Attaching the Housing
Installing the Housing on a Strand Procedure
Follow these steps to install the housing on an aerial strand.
1.
Loosen the strand clamp bolts.
2.
Lift the housing into proper position on the strand.
3.
Slip the strand clamps over the strand and finger-tighten the clamp bolts. This
allows additional movement of the housing as needed.
allows additional movement of the housing as needed.
4.
Move the housing, as needed, to install the coaxial cable and connectors. See
the diagram below for an example.
the diagram below for an example.
Signal Flow from Left to Right
T7314
Coax Out
Strand Clamps
Strand
Coax In
Signal Flow from Right to Left
T7315
Coax In
Strand Clamps
Strand
Coax Out
Note: Coax In may be switched with the Coax Out if you reverse the
amplifier module and feed the signal from right to left.
amplifier module and feed the signal from right to left.
Continued on next page