Cisco Cisco StadiumVision Mobile Wartungshandbuch
© 2011 Cisco Systems, Inc. All rights reserved.
Page 43 of 94
Configuring DHCP Options
The DMP auto discovers the SV Director server via DHCP and then auto registers
with SV Director. This discovery process uses Option 60 and Option 43 where
Option 60 is used to identify the DMP as the requesting device of Option 43
information. Option 43 is configured with the URL that the DMP will use for
registration with SV Director.
with SV Director. This discovery process uses Option 60 and Option 43 where
Option 60 is used to identify the DMP as the requesting device of Option 43
information. Option 43 is configured with the URL that the DMP will use for
registration with SV Director.
Cisco IOS DHCP Server
To configure the Cisco IOS DHCP Server for Option 60 and Option 43:
1. Access the configuration mode at the Cisco IOS CLI.
2. Configure the ip helper-address on the Video VLAN to point the DHCP server to
where this configuration will be done. If the DHCP server is configured on the
local switch where the DMPs are connected, this step is not required.
local switch where the DMPs are connected, this step is not required.
interface Vlan200
ip address 10.50.1.1 255.255.255.0
ip helper-address 10.131.130.1
(Router with DHCP Server Configured)
ip pim sparse-mode
3. Create the DHCP pool, which includes the necessary parameters, such as
default router and server name. This is an example DHCP scope:
ip dhcp pool
<pool name>
network
<ip network> <netmask>
default-router
<default-router IP address>
4. Add the Option 60 line with this syntax:
option 60 ascii DMP4310
5. Add the Option 43 line with this syntax:
option 43 ascii http://<
SV Director IP Address
>:8080/StadiumVision/dmp_reg
Note: You do not need to define a sub-option value for the Cisco IOS DHCP server.
For example, to configure Option 43 for Cisco DMP 4310 with the SV Director IP
address 10.50.1.27, add this line to the DHCP pool in the Cisco IOS CLI:
address 10.50.1.27, add this line to the DHCP pool in the Cisco IOS CLI:
option 43 ascii http://10.50.1.27:8080/StadiumVision/dmp_reg
Note: The Cisco IOS DHCP server is limited to one Option 43 for each DHCP pool,
so you can only configure a DHCP scope for a single device type. This should not
pose a problem since the recommendation is to use separate VLANs per service.
For example, Video VLAN for DMPs, Voice VLAN for IP phones, and Wireless
VLAN for APs.
so you can only configure a DHCP scope for a single device type. This should not
pose a problem since the recommendation is to use separate VLANs per service.
For example, Video VLAN for DMPs, Voice VLAN for IP phones, and Wireless
VLAN for APs.