Cisco Cisco 1 GHz GainStar Amplifier Installationsanleitung

Installing the Housing

To Install the Housing on a Strand (Aerial)

Complete the following steps to install the housing on a strand (aerial). The housing

does not need to be opened for strand installation.
Important: The minimum strand diameter should be 5/16 inch.

CAUTION:

Be aware of the size and weight of the housing while strand

mounting. Ensure that the strand can safely support the weight of

the housing.

1  Loosen the strand clamp bolts.
2  Lift the housing to the proper position on the strand.
3  Slip the strand clamps over the strand and finger-tighten the clamp bolts. This

allows additional movement of the housing as needed.

4 Move the housing as needed to install the coaxial cable and connectors. See the

diagram below.

5 Using a ½-inch torque wrench, tighten the strand clamp bolts from 6.8 Nm to 9.0

Nm. Make sure there is good mechanical contact between the strand and the

housing.
Note: A slight tilt of the housing face is normal. Cable tension will cause the

housing to hang more closely to vertical.

6 Connect the coaxial cable to the pin connector according to connector

manufacturer specifications.

7 Proceed to

Installing the Accessories.

OL-31945-02