APRILIA quasar 125 Benutzerhandbuch
48
use and maintenance
Quasar 50 - 100 - 125 - 180
BULBS
WARNING
Risk of fire.
K e e p f u e l a n d o t h e r f l a m m a b l e
K e e p f u e l a n d o t h e r f l a m m a b l e
s u b s t a n c e s a w a y f r o m e l e c t r i c
components.
CAUTION
Before proceeding to change a bulb, set
the ignition switch to "" and allow
some time for the bulb to cool down.
Wear clean gloves or use a clean, dry
Wear clean gloves or use a clean, dry
cloth to handle the new bulb.
Do not put your fingerprints on the
Do not put your fingerprints on the
bulb, as this may lead to overheating
and failure.
If you have handled the bulb with bare
hands, clean it with alcohol to avoid any
damage.
DO NOT PULL ON THE WIRES.
DO NOT PULL ON THE WIRES.
VERTICAL ADJUSTMENT OF THE
HEADLIGHT BEAM
HEADLIGHT BEAM
CAUTION
Beam inspection
procedures may vary from country to country.
Observe the law in force in the country of the
user.
Observe the law in force in the country of the
user.
For a quick beam inspection, place the
vehicle on level ground, ten metres away
from a vertical wall.
Switch on the low beam, sit astride the
vehicle and make sure that the light spot
on the wall is just below the horizontal line
of the headlight (about nine/tenths of
overall height).
vehicle on level ground, ten metres away
from a vertical wall.
Switch on the low beam, sit astride the
vehicle and make sure that the light spot
on the wall is just below the horizontal line
of the headlight (about nine/tenths of
overall height).
To adjust the headlight beam:
◆
Working on the vehicle front end, use a
screwdriver to turn screw (1):
TIGHTEN (clockwise) to lower the beam;
SLACKEN (anticlockwise) to raise the
beam.
screwdriver to turn screw (1):
TIGHTEN (clockwise) to lower the beam;
SLACKEN (anticlockwise) to raise the
beam.
When finished:
WARNING
Check for correct beam vertical setting.
50
100
1