Autotek autocad raster design 2010 Benutzerhandbuch

■

Enter b (Baseline) to set the text baseline by clicking two points in
the drawing to indicate the start point and the direction of the
baseline.

■

Enter j (Justify) to specify the justification method for the text.

■

The following prompt is displayed:

Specify justification [Left/Center/Right/Align/Mid/Fit] <Left>:

For more information, see 

 (page 227).

3 In the drawing window, select an insertion point for the text, subject to

the justification method.

For example, for left-justified text, select an insertion point that
corresponds to the lower-left corner of the text block.

The VText Edit dialog box is displayed.

4 Enter the text you want to place on your image and click OK.

5 The text is placed at the location that you selected.

NOTE If want to change the text, type e (Edit) to edit the text in the VText
Edit dialog box.

6 Do one of the following, depending on the VTools Removal Method you

selected in the Raster Design Options dialog box:

■

If None, you can press Enter to end the command.

■

If Rub, see 

 (page 153).

■

If REM, see 

 (page 176).

7 You can continue to replace raster text with vector text, use the COPYLAST

option, or press Enter to end the command.

NOTE The COPYLAST command displays the VText Edit dialog box where
the last text string you placed in the drawing is displayed. You can edit this
text string if necessary, then click OK and pick an insertion point for the copy.

■

You can justify text in the following ways:

■

Left, to place the insertion point at the left side of the text baseline.

Creating Single-Line Vector Text | 227