Trimble Outdoors thunderbolt 64057-00-eng Benutzerhandbuch
2 Setting up and Running the ThunderBolt E
14 Trimble ThunderBolt E GPS Disciplined Clock User Guide
System requirements
Hardware
•
For evaluation or engineering purposes:
–
The Trimble ThunderBolt E GPS disciplined clock starter kit, see
.
–
User-provided connectors and extension cords to connect the
ThunderBolt E module to the computer, antenna interface, and other
devices as required.
ThunderBolt E module to the computer, antenna interface, and other
devices as required.
•
For permanent installation:
–
ThunderBolt E GPS disciplined clock module
–
Trimble Bullet antenna
–
75–100 feet of approved cable (RG-6) with two M-M TNC connectors
Note – 50
Ω
or 75
Ω
RF cable can be used. Typical impedance mismatch will reflect only
0.5 dB of additional attenuation at 1575.42 MHz. See also
–
+24 VDC power supply
–
User-provided equipment to analyze the 10 MHz output frequency and the
1 PPS accuracy, and a BNC connector to connect them to the
ThunderBolt E module.
1 PPS accuracy, and a BNC connector to connect them to the
ThunderBolt E module.
–
User-provided connectors and extension cords to connect the
ThunderBolt E module to the computer, antenna interface, and other
devices as required.
ThunderBolt E module to the computer, antenna interface, and other
devices as required.
Computer
•
An office computer running a version of the Microsoft
®
Windows
®
operating
system (Windows NT or later)
System software
•
Trimble GPS Monitor software. The software is used to monitor the GPS
performance of the ThunderBolt E and to change its settings. The software is
compatible with the Windows 95, 98, 2000, and XP operating systems and with
the Windows Vista
performance of the ThunderBolt E and to change its settings. The software is
compatible with the Windows 95, 98, 2000, and XP operating systems and with
the Windows Vista
®
operating system. See
•
Trimble Standard Interface Protocol (TSIP). This consists of command packets
and report packets. See
and report packets. See
.