Troy-Bilt storm 2840 Benutzerhandbuch

The chute directional control is located on the left side of the 

dash panel.

To change the direction in which snow is thrown, squeeze 

• 

the button on the joy-stick and pivot the joy-stick to the 

right or to the left.
To change the angle/distance which snow is thrown, pivot 

• 

the joy-stick forward or backward.

To activate the heated grips, move the switch found on the rear 

of the dash panel into the ON position.

Never use your hands to clear a 

clogged chute assembly. Shut off engine and remain 

behind handles until all moving parts have stopped 

before unclogging.

The chute clean-out tool is conveniently fastened to the rear of 

the auger housing with a mounting clip. Should snow and ice 

become lodged in the chute assembly during operation, proceed 

as follows to safely clean the chute assembly and chute opening:

Release both the Auger Control and the Drive Control.

1. 

Stop the engine by removing the ignition key. 

2. 

Remove the clean-out tool from the clip which secures it to 

3. 

the rear of the auger housing. 
Use the shovel-shaped end of the clean-out tool to 

4. 

dislodge and scoop any snow and ice which has formed in 

and near the chute assembly.
Refasten the clean-out tool to the mounting clip on the 

5. 

rear of the auger housing, reinsert the ignition key and 

start the snow thrower’s engine.

While standing in the operator’s position (behind the snow 

thrower), engage the auger control for a few seconds to clear any 

remaining snow and ice from the chute assembly.