bobcat 2200d Benutzerhandbuch
Bobcat 2200 Diesel Vehicle
33
Operation & Maintenance Manual
ENGINE COOLANT
Engine Coolant Level Check
The coolant reserve tank is located under the dashboard
next to the brake fluid reservoir [Figure 14]. Raise the
access panel located on top of the dashboard to check
the coolant level before every operation.
next to the brake fluid reservoir [Figure 14]. Raise the
access panel located on top of the dashboard to check
the coolant level before every operation.
1. Check the coolant level of the reserve tank (2). If the
coolant is at or below the LOW mark, add water until
level reaches the FULL mark. If a leak is detected,
have it checked by a trained technician. See
following WARNING.
level reaches the FULL mark. If a leak is detected,
have it checked by a trained technician. See
following WARNING.
WARNING
•
Hot! Coolant reserve tank is pressurized. Do not
remove cap when engine is hot.
remove cap when engine is hot.
AIR INTAKE
CAUTION
CAUTION
•
Do not drill into the driver-side frame. Failure to
heed this caution could damage the engine by
allowing excessive contamination to enter the air
intake system.
heed this caution could damage the engine by
allowing excessive contamination to enter the air
intake system.
Air Filter Replacement
The air filter should be inspected periodically and
replaced when necessary. Filter changes should not
exceed the recommended interval. See PERIODIC
SERVICE SCHEDULE on page 24. More frequent
service may be required in extremely dirty operating
environments. In the event of a loss of power, sluggish
acceleration, or a roughly running engine, service the air
filter immediately.
replaced when necessary. Filter changes should not
exceed the recommended interval. See PERIODIC
SERVICE SCHEDULE on page 24. More frequent
service may be required in extremely dirty operating
environments. In the event of a loss of power, sluggish
acceleration, or a roughly running engine, service the air
filter immediately.
Air Filter Removal
1. Release both canister tab lock [Figure 25].
2. Pull the canister cap away from the canister.
3. Remove the air filter cartridge. See following NOTE.
NOTE: The air filter cartridge is specifically designed
for this engine. It only fits into the canister one
way. Use only the Bobcat part (102498601 CC)
designed for this engine.
way. Use only the Bobcat part (102498601 CC)
designed for this engine.
Figure 25 Air Filter Cartridge
Air Filter Installation
1. Push the new air filter cartridge onto the inside
canister nozzle.
2. Place the canister cap, marked TOP, on the top
center of the canister.
3. Secure the canister cap with both tab locks.