Dacor DR30DH-C Benutzerhandbuch

Installation Instructions

2.  To install the bracket, place it against the wall in the mounting 

location. Using a drill with 1/8” diameter drill bit, drill four (4) 

1 5/8” deep pilot holes perpendicular to the screw seating 

surfaces shown below. Attach the bracket to the wall as 

shown with the four (4) included #12 x 1 3/4 screws.

Preparing for Installation (cont.)

1.  Determine the suitability of wall mounting the anti-tip bracket. 

To use the wall mount option, the range front panel must not 

be more than 27 1/2” from the wall and the bracket screws 

must be able to thread into the base plate inside the wall 

behind. The notches on the sides of the bracket indicated the 

minimum required height of the base plate inside the wall and 

that any floor covering is not too thick for proper screw thread 

engagement. 

To determine if the base plate is high enough:
◊  Determine the location of the range center line and front 

panel when the range is in its final position based on 

the product dimensions on page 5 and the actual 

cabinet/cutout dimensions used for the installation.

◊  Determine and mark the required position of the anti-tip 

bracket, based on the diagram above. Push the bracket 

up against the wall in the mounting location.

◊  Using a pencil, make a dot next to the notches on both 

sides of the bracket. Determine if the base plate is as 

high at the notches by drilling test holes into the wall at 

both dots with a 1/16” drill bit. Drill just deep enough to 

see if the bit contacts the base plate. If the bit contacts 

the base plate the location will support wall installation of 

the anti-tip bracket. If you do not contact the base plate, 

the wall mounting method may not be used and the floor 

mounting method must be suitable, or the wall must be 

modified so that the base plate is above the notches.

CL

CL

#12 x 1 3/4” screw, 

4 places

Range front

panel

Bracket 

center line

Range 

center line

Back wall

11” 

(27.9 cm)

Cabinet  

face below 

countertop

This hole lines up with 

bracket center line

26 1/2” 

(67.3 cm) 

to 27 1/2” 

(69.9 cm)

Wall

Anti-tip 

bracket

Drywall

Notch

Base plate