Dacor DR30DH-C Benutzerhandbuch

Installation Instructions

To make the range easier to move, remove the door to reduce 

weight.

•  Do not attempt to disengage the hinge catches with the 

door removed from the oven. The hinge springs could 

release causing personal injury.

•  Do not lift or carry the oven door by the handle.

1.  Open the door to its fully opened position.
2.  Using a screwdriver, rotate the catch over the retaining arm 

on each hinge.

3.  Lift the oven door to about a 15° angle from the vertical 

position.

4.  Hold the door with both hands just below the handle and pull 

it away from the oven while continuing to lift.

When used, the optional island trim or optional 6 or 9 inch 

backguard must be installed before sliding the range into 

place. Install them according to the accompanying installation 

instructions.

Remove the 3 1/4” side panels if both the top and the front of the 

range will be self-rimmed (see pages 7 and 8). Remove 

them before sliding the range into place.
1.  Remove the two screws on the side of the range and the one 

just above the kick panel that hold the side panel in place.

2.  To remove, slide the panel toward the back of the range, off 

of the ball studs.

Catch

Retaining arm