Dacor DR30DH-C Benutzerhandbuch

Installation Instructions

Electrical Connection

•  Wire the range only in compliance with local ordinances.
•  Before proceeding, turn off power to the electrical supply 

at the circuit breaker panel for fuse box. Do not turn on 

power to the range until instructed to do so in the Verifying 

Proper Operation section of these instructions.

•  Improper connection of the electrical wiring can cause an 

electric shock hazard and damage the appliance. Dacor 

is not responsible for damages resulting from improper 

installation.

•  The ground terminal (or lead) on the appliance must be 

connected to a grounded, metallic, permanent wiring system 

or grounding conductor.

•  Do not use an extension cord with this appliance. Such use 

may result in fire, electric shock or other personal injury.

•  Do not install a fuse in the neutral or ground circuit. A fuse 

in the neutral or ground circuit may result in an electric 

shock hazard.

IMPORTANT:
•

Some models come pre-wired at the factory with a 4-wire 

appliance cord for connection to a 14-50R electrical 

receptacle as specified on page 3. If the range being 

installed is pre-wired, skip to Gas Connection on page 18. 

This section does not apply to pre-wired units.

•

Do not disconnect any of the wires inside the range electrical 

box unless instructed to do so.

•

Make sure that the 

conduit or appliance 

cord is long enough 

to allow the range 

to be pulled out 

for service without 

disconnecting it from 

power.

Refer to the product data label (see inside cover) for power 

requirements.
There are four possible ways to wire the range:
•

4-wire appliance cord, where local codes permit 

•

3-wire appliance cord, where local codes permit

•

4-wire conduit (see page 16)

•

3-wire conduit, where local codes permit (see page 16)

The sections on the following pages give directions for connecting 

each type of wiring harness.

Put slack in 

electrical wiring 

and gas line

Do not connect the green appliance wire to the neutral (white) 

supply wire unless local building codes permit.

1.  Remove the range electrical access cover from the back of 

the range.

2. 

IMPORTANT: If using a 4-wire connection, loosen the 

grounding screw and remove the neutral to ground jumper 

link from the terminal block. Leave the link in place for 3-wire 

connections.

3.  Remove the conduit bracket from the bottom of the range 

electrical box.

4.  Disassemble and remove the strain relief from the appliance 

cord (not included). Insert the tabs on the two parts of 

the strain relief into the hole on the bottom of the box and 

reassemble it so that the tabs are below the box and the 

strain relief itself is inside the box.

Remove link on  

4-wire installations

Remove conduit bracket 

before strain relief installation

Terminal block

Strain relief

Reassemble with tabs 

below and clamp above

Bottom of range  

electrical box