Dacor DR30DH-C Benutzerhandbuch

Installation Instructions

L1 terminal

L1 terminal

L2 terminal

L2 terminal

Black wire

Red wire

White wire

Green wire

Red wire

White wire

Black wire

Conduit strain 

relief nut

Conduit strain 

relief nut

Neutral terminal

Neutral terminal

Neutral to ground 

jumper link

Neutral to ground 

jumper link removed

Grounding screw

Electrical Connection (cont.)

Do not connect the green appliance wire to the neutral (white) 

supply wire unless local building codes permit.

1.  Remove the range electrical access cover from the back of 

the range.

2. 

IMPORTANT: If using a 4-wire connection, loosen the 

grounding screw and remove the neutral to ground jumper 

link from the terminal block. Leave the link in place for 3-wire 

connections.

3.  Remove the nut from the conduit strain relief (not included).
4.  Slide the wires and the end of the strain relief into the hole on 

the bottom of the range electrical box.

5.  Before connecting the wires, slide the strain relief nut over 

the wires and thread it onto the conduit strain relief inside the 

box. Tighten into place.

6.  Connect the white wire to the neutral terminal in the box.
7.  Connect the black wire to the L1 power supply terminal.
8.  Connect the red wire to the L2 power supply terminal.
9.  If using a 4-wire connection, connect the green wire to the 

grounding screw inside the box.

10.  Replace the range electrical access cover.

Remove link on  

4-wire installations

Terminal 

block

Bare wire 

connections

Loop and  

spade terminal 

connections