Dacor DR30DH-C Benutzerhandbuch

To avoid personal injury or damage to the door from it falling off 

its hinges:
•  Make sure that the notch on the bottom of each hinge rests 

on top of the lower lip of each hinge receptacle before 

attempting to open the oven door.

•  Rotate the hinge locks toward the front of the range 

immediately after installation of the door.

1.  Grasp the oven door on opposite sides and hold it at a 15° 

angle from the front of the oven. Slide the hinges into the 

hinge openings, resting the bottom of the hinge arms on the 

hinge receptacles. Continue to hold the door at a 15° angle 

with one hand while pushing in on each of the bottom corners 

of the door. Push until the notch on the bottom of each hinge 

slips over the lower lip of each hinge receptacle.

2.  Lower the door to the fully opened position.
3.  Rotate the two hinge locks toward the oven.
4.  Slowly and carefully open and close the door completely to 

ensure that it is properly installed.

5.  Remove any packaging from inside the oven.

Installation Instructions

Cooktop Assembly

Never attempt to operate the range’s cooktop with any of the 

burner rings, burner caps or grates removed.

1.  Remove the burner rings, burner caps and grates from their 

shipping packages.

2.  Assemble the burners and grates as shown below.

Burner 

ring

Burner 

ring

Pin on burner 

base

Igniter on 

burner base

Igniter 

hole

Outer burner 

cap

Inner burner 

cap

SimmerSear 

burner

Standard 

burners

Grates

Spill tray

Ridge on 

bottom of 

burner cap

Ridge on bottom of 

on inner burner cap

Lower lip 

of hinge 

receptacle

Notch on bottom

of hinge