Dacor DR30DH-C Benutzerhandbuch

Installation Instructions

Verifying Proper Operation

•  Before operating the range, read the accompanying use and 

care manual completely.

•  Make sure that power to the range is turned off at the circuit 

breaker or fuse box and that the gas is turned off at the gas 

supply valve before proceeding.

•  The cooktop must be properly grounded at all times when 

electrical power is applied.

1.  Before beginning the test procedure, ensure that all cooktop 

control valves are in the 

OFF position, and all burner rings, 

burner caps and grates are properly positioned on the spill 

tray. Remove any packaging from inside the oven.

2.  Turn on the gas supply at the shut-off valve.
3.  Plug in the appliance cord, if applicable. Turn on power to the 

range at the circuit breaker or fuse box.

4.  Perform the following ignition test for all of the burners:

◊  Push in and turn one 

of the control knobs 

counterclockwise to the 

HIGH position. Only the 

igniter for the selected 

burner will spark. It may take up to four seconds for the 

gas to ignite, at which time the igniter will stop sparking. 

If ignition does not occur within four seconds, turn the 

knob to the 

OFF position, wait for at least five minutes to 

allow any gas to dissipate, then repeat the test.

◊  Once the burner lights, the control knob can be rotated 

counterclockwise from 

HIGH to LOW to adjust the flame 

height progressively.

◊  When the unit is installed 

properly, the flame will be 

steady. It will also have a 

sharp, blue inner cone that 

will vary in length proportional 

to the burner size. The flame 

will be reduced by the Smart 

Flame™ feature under the 

grate fingers to increase grate 

life.

5.  Set the clock according to the use 

and care manual. 

6.  Press the 

BAKE key on the control panel. The default bake 

temperature should appear on the display.

7.  Enter the temperature of 350°F on the keypad.
8.  Press 

START. The display should show the 

BAKE symbol and the preheating temperature.

9.  After approximately three (3) minutes, the oven 

should begin to heat. Press the 

CANCEL-SECURE key to 

stop the oven heating process.

If either the oven or cooktop does not operate properly, 

follow these troubleshooting steps:
1.  Verify that power and gas are supplied to the range.
2.  Check the electrical connections and gas supply to ensure 

that the installation has been completed correctly.

3.  Repeat the bake test or burner ignition test.
4.  If the appliance still does not work, contact Dacor Distinctive 

Service at (877) 337-3226. Do not attempt to repair the 

appliance yourself. Have the model and serial numbers 

available when you call. See inside cover for location.

Dacor is not responsible for the cost of correcting problems 

caused by a faulty installation.

Installation Checklist

To ensure a safe and proper installation, the following checklist 

should be completed by the installer to ensure that no part of 

the installation has been overlooked.

 

□

Has the plastic coating been peeled off of the outside of the 

range? Have all packaging materials been removed from 

inside the oven?

 

□

Are all leveling legs extended down to make contact with the 

floor? Is the unit level? See page 18.

 

□

Is the range secured in place with the provided anti-tip 

bracket and foot according to these instructions? See page 

10.

 

□

Is the range wired and grounded according to these 

instructions and in accordance with all applicable electrical 

codes? Has the electrical access cover been replaced? See 

Pages 3 and 16.

 

□

Has the gas supply inlet pressure been measured to ensure 

that it does not exceed the maximums stated in these 

instructions? See page 4.

 

□

Is the range connected to the gas supply according to these 

instructions and in accordance with all applicable codes? See 

page 18.

 

□

Did the installer check the gas supply for leaks?

 

□

Is the oven door properly installed according to these 

instructions? See page 19.

 

□

Are the burners and grates properly installed according to 

these instructions? See page 19.

 

□

Has proper operation been verified?

 

□

Has the warranty been activated on-line or the warranty card 

been filled out completely and mailed?

1

2