cortech datalog 3-molynx Benutzerhandbuch

Molynx Visilynx CCTV Module - Page 1 of 6

CORTECH DEVELOPMENTS LTD

The Datalog 3 software will operate with the Molynx Visilynx, Visilynx2 and TTX600 series
CCTV matrix when connected via a suitable interface to a Datalog serial port.

When used with the Visilynx series a Card (PCBV309) should be fitted with PCCON2
firmware to allow Datalog control.

A subset of the commands can sent by the Datalog can also be used to control a TTX309
standalone interface which converts the commands into the standard Molynx Data
Protocol, allowing the PC, etc. to control Molynx receivers. The TTX309 can also control a
Molynx 600-series, either by being the sole controller connected directly to a 640 video
switching unit or by acting as a slave keyboard on an existing system. The slave keyboard
address is selectable.

The Datalog will allow the automatic call up upon alarm condition of up to four cameras to
preset positions and supports two banks of four monitors for alarm switching.

The Datalog will send the current time/date at program start up and whenever the time is
changed on the Datalog PC.

As only a subset of the PCCON2 commands are available with the TTX309, some minor
differences in operation may be expected. See 

Product Variations