cortech datalog 3-molynx Benutzerhandbuch
Datalog
3
- SMS Software Application Sheet
Molynx Visilynx CCTV Module - Page 3 of 6
CORTECH DEVELOPMENTS LTD
Configuration
Only users with ‘User Setup’ privilege can set up camera switching via the Datalog on
screen menus. Log onto the system and enter the select the ‘User Setup’ menu under the
‘System’ menu. Once the setup window is displayed select the relevant setup button.
screen menus. Log onto the system and enter the select the ‘User Setup’ menu under the
‘System’ menu. Once the setup window is displayed select the relevant setup button.
The CCTV setup window consists of a table of all alarm zones on the system showing any
cameras/pre-position numbers allocated to the zone. If an entry is zero or blank then that
particular camera/pre-position will not be switched upon alarm.
cameras/pre-position numbers allocated to the zone. If an entry is zero or blank then that
particular camera/pre-position will not be switched upon alarm.
The alarm monitor bank edit boxes allow the user to specify the monitor(s) which will be
used for alarm purposes. These are split into two banks and the cameras will be displayed
on alternate banks in multiple alarm conditions. If only one bank is required or less than
four monitors are needed for alarm switching, then leaving the relevant monitor(s) as zero
will override alarm bank and monitor call up actions.
used for alarm purposes. These are split into two banks and the cameras will be displayed
on alternate banks in multiple alarm conditions. If only one bank is required or less than
four monitors are needed for alarm switching, then leaving the relevant monitor(s) as zero
will override alarm bank and monitor call up actions.
For example if a second alarm monitor bank is not required then leave all four bank 2
monitors as zero.
monitors as zero.
The serial port and data rate settings are confirmed in the status bar at the bottom of the
setup window.
setup window.
Press the ‘Save’ button to store the changes and ‘Abort’ to exit setup without saving. The
‘Text’ button allows a test transmission which should simulate an alarm on the selected
zone.
‘Text’ button allows a test transmission which should simulate an alarm on the selected
zone.
Operation
Automatic Camera Switching Operation
The Datalog can pre-position up to 4 cameras upon alarm and allocate these 4 camera
views to 4 monitors. The Datalog supports up to 2 banks of 4 monitors if required. Upon
the 1
views to 4 monitors. The Datalog supports up to 2 banks of 4 monitors if required. Upon
the 1
st
alarm bank 1 monitors will be allocated cameras and subsequent alarms will be
allocated to bank 2, then bank 1, then 2 etc.
In situations when 2 banks are not required then a single set of alarm monitors may be
used.
used.
When the Datalog is reset in a multiple alarm situation then camera views will be set to the
alarm positions as each alarm is reset. Once the last alarm that references a given monitor
is reset, the Datalog will issue the ‘Sequence Recall 1’ command to the specific monitor.
alarm positions as each alarm is reset. Once the last alarm that references a given monitor
is reset, the Datalog will issue the ‘Sequence Recall 1’ command to the specific monitor.