fetco cbs-2032e Benutzerhandbuch

Operating Instructions

Control Panel Functions

Only switches that are active are illuminated.
Switches that are inactive or disabled are invisible.

Main Power Switch

Controls all power to brewer

Indicator lamp at top of panel.

Control Panel On/Off Switch

Affects only control panel. Does

not disconnect main power.

Flashing = Off

Lit = On

Invisible = Main Power Off

Display

”FILL” = Water tank is filling.

”LO XXX” = Unit is heating, not

ready to brew. (XXX = actual
temperature.)

Blank = Ready to brew.

Also displays error messages.

[

Stop Switches

Stops brew cycle

Lit = Brew cycle in progress

Invisible = Not brewing, or dripping

in progress

Brew Switches

Starts brew cycle

Must be held in for 1 second

Flashing = Brew cycle in progress

Lit = Ready to brew

Invisible – Not ready to brew, or

batch disabled
(See Programming Section)

]

Hot Water Switch

Dispenses hot water from faucet

Hold in to dispense

Brewing

1. Turn the main power switch and control

panel switch on.

2. Prepare a brew basket with the correct size

filter and appropriate amount of coffee.

3. Slide the brew basket completely into the

rails.

4. Place a clean, empty, preheated dispenser

under the brew basket.

5. Select a batch from the available choices,

and hold the corresponding BREW button in
for 1 second to start the brew cycle.

6. The STOP button will illuminate, and the

selected BREW button will flash, indicating
that brewing is in progress. All other BREW
buttons will extinguish.

7. When the brew cycle is finished, the STOP

button will extinguish and the BREW button will
continue flashing, indicating that coffee may still
be dripping from the bottom of the brew basket.

8. Before removing the brew basket or dispenser,

visually verify that dripping has stopped.

Notes:

Preheat dispenser by filling at least ½ full with
water at brewing temperature. Allow it to sit for
at least 15 minutes before draining.