Schneider Electric Pty. Ltd. S1B15258 Benutzerhandbuch

6 of 20

5200UZI WHC2_5921 and 5200EZI WHC2_5922

USB ZB Interface and Ethernet ZB Interface User’s Manual

3.2 5200UZI WHC2_5921 USB ZB Interface

The USB type interface is normally plugged directly to a USB port on a PC or to the
special port provided in the Wiser Home Control Mk 2. The interface unit is powered
by the active USB port. When the interface unit is powered on it can connect to
(join) an existing ZigBee network using E-mode.
A freestanding PC can be used. The PC must be connected to the Internet when
downloading the Zoolkit software application. Be sure to keep the PC within range
of the ZigBee network when using this configuration. The PC, USB ZB interface and
the ZigBee network are shown in Figure 2.

Figure 2. USB ZB Interface installed in a PC

The USB ZB interface can also be installed in the Wiser Home Control Mk 2. During
the programming and setup of the Wiser unit, a PC must be attached to the local
Ethernet network. Figure 3 shows a typical configuration using the Wiser unit.

Internet

PC with Zoolkit, C-Bus Toolkit

and PICED software loaded

Router or

switch

Wiser Home Control

USB ZB Interface

ZigBee network

Figure 3. USB ZB Interface use with a Wiser Home Control Mk 2

PC with Zoolkit software loaded

Internet

Router or
switch

USB ZigBee Interface

ZigBee network