Appro Technology Inc RF1 Benutzerhandbuch
3.2 Mounting and Positioning the Compact dome
Camera Mounting: (refer to Figure3.2.1~3.2.6)
Step 1: Position the alignment sticker in the desired location for the camera.
Step 2: Use a 6mm drill bit to make required holes approximately 25mm deep.
Step 3: Insert wall anchors.
Step 4: Affix the camera base using the screws provided.
Step 5: Adjust the Lens.
Step 6: Affix the dome using the screws provided.
Step 7: Insert the weatherproof rubber screw coverings over the screws ensuring a tight seal.
ngs over the screws ensuring a tight seal.
Step 8: Using the Ethernet cable connect to the Ethernet port. Connect the other end of the
Ethernet cable your network. If you are using a PoE hub, connect the IP camera to the hub via an
Ethernet cable, which will provide transmission of both power and data over a single cable.
Step 8: Using the Ethernet cable connect to the Ethernet port. Connect the other end of the
Ethernet cable your network. If you are using a PoE hub, connect the IP camera to the hub via an
Ethernet cable, which will provide transmission of both power and data over a single cable.
Step 9: Connection with 12V DC Power Adaptor.
Step 9: Connection with 12V DC Power Adaptor.
Figure 3.2.1
Figure 3.2.2
Figure 3.2.3
Figure 3.2.4
Figure 3.2.5
Figure 3.2.6
10