Wilson Electronics LLC 460003 Benutzerhandbuch
13
14
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com. Mon.- Fri. Hours: 7 am to 6 pm MST.
oscillation (feedback) . First, make sure that all connections are tight .
Then turn gain to minimum and slowly increase the gain until the light
turns red . Reduce the gain to the previous setting that had a green
light . It will take 1 minute for the light to turn back to green, or unplug
and plug in the Signal Booster to reset it . When you turn down the gain,
you are reducing the inside coverage area . If the amount of coverage
area is sufficient for your needs, and the light is green, the installation
is complete . If the coverage area is not large enough, it is necessary
to increase the separation distance of the antennas by moving them
horizontally or vertically farther apart, or both . Then increase the gain
until the red light comes on, and then slightly keep decreasing the gain
until the green light appears, waiting one minute in between increments
or resetting the Signal Booster by unplugging and plugging it back in .
If after separating the antennas your coverage area is still too small,
contact Wilson Electronics Technical Support Team for assistance .
4. BLINKING ORANGE & RED
If one or more of the lights on the Signal Booster are blinking orange
and red, this indicates that the Signal Booster is experiencing extreme
receiver overload and has shutoff . The outside antenna must be turned
away from the cell tower until the light is no longer flashing orange and
red . Contact Wilson Electronics Technical Support Team for assistance .
5. BLINKING RED
If one or more of the lights on the Signal Booster are blinking red, this
means that the Signal Booster has shutoff due to close proximity to the
handset or mobile device . Increase the distance between the handset
and the Inside Antenna until the light is no longer flashing red . Contact
Wilson Electronics Technical Support Team for assistance .
6. LIGHT OFF
If one or more of the lights on the Signal Booster are off, this means
that the gain has been turned all the way down and the band is in
Power Save Mode . Increase the gain until the light turns on . If there
are bands that are not being used in the local coverage area, this will
reduce energy consumption .
reduce energy consumption .
Note:
Oscillation (feedback) can occur when the Outside Antenna is too
close to the antenna inside the house. An oscillation in a Signal
Booster is similar to when a microphone is too close to a speaker
in a sound system, resulting in a loud whistle. An oscillation in the
Signal Booster, if allowed to occur, can affect nearby cell towers
ability to handle calls.