Robert Bosch Pty Ltd VIMA01 Benutzerhandbuch
PROTOCOL SPECIFICATION
F005VP0801
ROBERT BOSCH
(AUSTRALIA) PTY. LTD.
A.B.N. 48 004 315 628
SMARTRA III IMMOBILISER
Page 15 of 49
Issue Number:
1.0
Dev No.
3881
Valid from:
14/2/06
Print Date:
28 March, 2007
© THIS DRAWING IS THE EXCLUSIVE PROPERTY OF ROBERT BOSCH (AUSTRALIA) PTY. LTD. WITHOUT THEIR CONSENT IT MAY NOT BE REPRODUCED OR GIVEN TO THIRD PARTIES.
DEV04205.9/I-1
4.4 4Bh - Transponder IDE (Pre ID Matching)
4.4.1 0x4B – (Existing) Pre Secret Encryption Key – kept for backwards compatibility
CU Request :-
49 02 4B 4D
SMARTRA2 Response:-
69 05 IDE1 IDE2 IDE3 IDE4 Checksum
IDE1..IDE4
:-
32
bit
Identifier.
4.4.2 0x4B – New – Secret Encryption Key – with Encryption check.
CU Request :-
49 08 4B RN1
RN2
RN3
RN4
RN5
RN6 CS
RN1..RN6 :- Random Number bytes (00-FF)
Note :-
RN1..6 can be based on the 4 byte random number from the Transponder Authentication
command (refer to “4.5 Transponder Authentication”). This will avoid extra EMS processing to generate
a random number.
SMARTRA3 Response:-
a random number.
SMARTRA3 Response:-
69 0D Return IDE1 IDE2 IDE3 IDE4 ERN1
ERN2
ERN3
ERN4
ERN5
ERN6
Smartra
State
CS
Return :-
0x00 = transponder communications OK
0x01 = transponder missing or incorrect communications
0x02 = Antenna coil Open/Short Detection
IDE1..IDE4
:-
32
bit
Identifier.
ERN1 .. ERN6 :- Encrypted Random Number using Secret Encryption Key (SEK)
Smartra State :-
Smartra State :-
0x01 = Learnt / Taught
0x02 = Virgin
0x03
=
Neutral
Note : - SMARTRA will take up to 110ms to start sending IDE response to the CU.
- When Transponder is missing the Return value will be 0x01 and IDE1 to IDE4 = (0x00 0x00
0x00 0x00).
- When Smartra3 receives the IDE request with the Random Number and it is in:
0x00 0x00).
- When Smartra3 receives the IDE request with the Random Number and it is in:
• [virgin] or [neutral] state the ERN1..6 shall be the encrypted random number using a
default key.
• [learnt] state the ERN1..6 shall be the encrypted random number using the Secret
Encryption Key (SEK).
- Default encryption key will be described in Encryption Software Integration Document.