Sea Air and Land Communications 12865 Benutzerhandbuch
SALCOM 12-86-5000 Miniature Paging Transmitter PCB
ISSUE: 12865000UC 0714
Sea Air and Land Communications Ltd
Page 2
PROGRAMMING
In order to program the12-86-5000, programming software should be downloaded
from the Salcom website (www.salcom.co.nz).
from the Salcom website (www.salcom.co.nz).
A Salcom 12-47 programming lead is required to program the 12-86 transmitters (the
same lead used to program the 11-85 transmitters). This may be purchased
separately. The 12-47 programming lead requires the availability of a PC with a serial
port, running windows XP.
same lead used to program the 11-85 transmitters). This may be purchased
separately. The 12-47 programming lead requires the availability of a PC with a serial
port, running windows XP.
Connect the 12-47 as shown below, with the dot (circled in yellow) on the 12-47
socket towards the centre of the PCB (mating with the square pad).
socket towards the centre of the PCB (mating with the square pad).
The 12-86 Programming Software allows the transmitter frequency and button
messages to be set.
messages to be set.
1
Press “Connect”. The red LED will light, as a message is transmitted. After
the message has been sent, the green LED above the 4
the message has been sent, the green LED above the 4
th
button will light for
approximately 1 second. The status at the bottom of the 12-86 PSD will
indicate if successfully connected.
indicate if successfully connected.
2
Press “Read”. The current configuration is read from the 12-86-5000.
3
Make any required changes.
4
Press the “Program” button.
5
Press “Disconnect”, then remove programming lead.
SALCOM 12-86-5000 Miniature Paging Transmitter PCB
ISSUE: 12865000UC 0714
Sea Air and Land Communications Ltd
Page 3
General Configuration
Button Messages: Select the button to view the message, RIC and beep level
assigned to that button. New button settings can be entered, but
will not be written until the program button is pressed. The
program button only needs to be pressed after all button details
have been populated.
will not be written until the program button is pressed. The
program button only needs to be pressed after all button details
have been populated.
Frequency:
The transmit frequency between 440 and 470MHz to be set,
25kHz channel spacing.
25kHz channel spacing.
Pager Type:
If set to “alphanumeric”, then any message can be set into the
message box, and can only be used with pagers that support
alphanumeric messages. When “numeric” is set then only
0,1,2,3,4,5,6,7,8,9,0,[,],-,E and U characters can be used. Tone
only pagers are supported by leaving the message box empty.
message box, and can only be used with pagers that support
alphanumeric messages. When “numeric” is set then only
0,1,2,3,4,5,6,7,8,9,0,[,],-,E and U characters can be used. Tone
only pagers are supported by leaving the message box empty.
Beep Level:
Pager beep priority set - 1 highest, 4 lowest.
RIC Code:
Pager ID. Valid codes are 0000008 to 2000000