Sea Air and Land Communications 12865 Benutzerhandbuch

SALCOM 12-86-5000 Miniature Paging Transmitter PCB

ISSUE: 12865000UC 0714 

Sea Air and Land Communications Ltd

Page 6

RF Frequency

UHF: 440-470MHz Synthesized.

Dimensions.

61mm x 31mm x 6mm. 

Supply Voltage

3 volt CR2032 button cell. 

Power Consumption

Sleep:100nA, LED flashing:1mA,
Transmit:48mA

Battery Life

Approx 1000 transmissions.  Approx 10 years
standby.

Temperature limits

-10 to +55deg, -30 to +60 on request.

Environmental
protection

Needs  protection from weather and should
be mounted in an enclosure.  When used
without an enclosure the unit can be
damaged by ESD.  

Channel Spacing

25kHz

Output Power

-5dBm

Modulation

Carrier FSK with NRZ data

Deviation

+/-4.5kHz

Transmit Duty Cycle

Up to 20%, 30 seconds continuous

Baud Rate

512 Baud

Discrete Inputs

5 Push buttons factory fitted.  Can be
grounded to remotely operate.

Type Approvals

AS/NZS 4769.1:2000  and EN 300 224-2. 
Tested to and meets FCC Part 90.

Aerial Integrated 

PCB 

SALCOM 12-86-5000 Miniature Paging Transmitter PCB

ISSUE: 12865000UC 0714 

Sea Air and Land Communications Ltd

Page 7

Care must be taken when replacing the CR2032 coin cell.  The battery must be fitted
with the ‘+’ up and the ‘-’ touching the PCB.  Incorrect battery installation will rapidly
discharge the coin cell, and may damage the transmitter.

After battery replacement, test that the 12-86 is functional by sending a test message
and verifying the red LED lights.   If the unit fails to operate, remove battery, confirm
correct battery orientation and reinsert.

Our Products are warranted for a period of 12 months from date of purchase against
faulty materials and workmanship.   

Should any fault occur the unit should be returned to the vendor, freight pre-paid.
Please include a description of the fault to assist with prompt return. 

Any unauthorized alterations or repairs will invalidate the warranty.

All information provided in this document is carefully prepared and offered in good
faith as a guide in the installation, use and servicing of our products.  

Installers must ensure that the final installation operates satisfactorily within the
relevant regulatory requirements. We accept no responsibility for incorrect installation.

We reserve the right to change products, specifications, and installation data at any
time, without notice.

PO Box 76-237, 10 Magdala Place, Christchurch, New Zealand

Phone: (03) 379-2298    Fax: (03) 365-1580    Email: info@salcom.co.nz