HID Global Corporation 4045 Benutzerhandbuch
HID
CORPORATION
27
LED INDICATION DURING PROGRAM MODE
A slow blinking yellow LED indicates that the unit is in
program mode.
When the yellow LED stops blinking and is OFF completely,
the unit is no longer in program mode.
A steady yellow LED indicates an error condition:
program mode.
When the yellow LED stops blinking and is OFF completely,
the unit is no longer in program mode.
A steady yellow LED indicates an error condition:
1- you are trying to enter a card or PIN which is already
stored in another User Location
2- you have pressed the wrong key in a command
stored in another User Location
2- you have pressed the wrong key in a command
sequence
Press * to clear the error condition and then enter a new code
or PIN, or re-enter the command sequence as required. If the
unit does not go into program mode, contact your dealer or
HID Technical Support.
or PIN, or re-enter the command sequence as required. If the
unit does not go into program mode, contact your dealer or
HID Technical Support.
BEFORE YOU START…
Before programming cards, try to determine:
•
How many cards do I have to enroll? If you have
more than 25 you may want to batch enroll them. If you
have fewer, you may want to program one at a time.
more than 25 you may want to batch enroll them. If you
have fewer, you may want to program one at a time.
•
How are the cards encoded: What is the bit format,
ID numbers and facility code? If you have sequentially
numbered cards with 26-bit format and the same facility
code, you can batch-enroll them from the keypad.
Otherwise you must program them individually or batch-
enroll by sequentially placing the cards in front of the
reader. Note that if you choose to add new cards
manually (via the keypad), the facility code must be
entered into the unit first. For the programming
sequence used to enter the 3-digit facility code, see
Table 2, item 32.
ID numbers and facility code? If you have sequentially
numbered cards with 26-bit format and the same facility
code, you can batch-enroll them from the keypad.
Otherwise you must program them individually or batch-
enroll by sequentially placing the cards in front of the
reader. Note that if you choose to add new cards
manually (via the keypad), the facility code must be
entered into the unit first. For the programming
sequence used to enter the 3-digit facility code, see
Table 2, item 32.