ADC Telecommunications Inc. PSM0800M Benutzerhandbuch
FlexWave Prism Remote Unit RF Module Installation Guide
Page 35
TECP‐77‐141 Issue 6 • 300001744178 Rev F • July 2014
©2014 TE Connectivity
Latches on Legacy Dual‐Bay 40W RF Modules
For Legacy Dual‐Bay 40W RF Modules, secure four latches, as shown in
Four latches in a
Legacy Dual-Slot 40W
RF Module
Legacy Dual-Slot 40W
RF Module
Figure 20. Legacy Dual‐Bay 40W RF Module Latches
Verify that the RF Module Mounting Hook is Engaged
1
Verify that the RF Module Mounting Hook is engaged correctly by pulling the module away from the heat sink.
The RF Module should not move. If the RF Module moves during this check, repeat all the steps starting at
The RF Module should not move. If the RF Module moves during this check, repeat all the steps starting at
through this step.
Connect the RF Module Cables
The steps to connect the RF Module cables have been separated into two different procedures; follow the steps
that correspond to the RF Module being installed.
that correspond to the RF Module being installed.
•
•
.