ADC Telecommunications Inc. PSM0800M Benutzerhandbuch
FlexWave Prism Remote Unit RF Module Installation Guide
Page 37
TECP‐77‐141 Issue 6 • 300001744178 Rev F • July 2014
©2014 TE Connectivity
Refer to the graphic that corresponds to the RF Module being installed into a single bay of the PRU:
•
•
HDM RF Module:
Bay A
Bay D
Bay C
Bay B
SeRF
Module
TX0/RX0
RX1
DIV
PRIM
PWR
Note routing of
high-speed cables
high-speed cables
Note bend
radii ≥ 1-inch
radii ≥ 1-inch
Edge of Connector Interface Panel
Cable connections for a Single-Slot RF Module
Figure 21. Cable Connections for Single‐Bay RF Modules
CAUTION!
Ensure that all cable bends are below the top edge of the Connector Interface Panel as indicated by the dashed
line in the preceding figure. Failure to correctly position the cables could inhibit closing the PRU door, which can
result in damage to the cables.
line in the preceding figure. Failure to correctly position the cables could inhibit closing the PRU door, which can
result in damage to the cables.