Nokia of America Corporation BBTRX-06 Benutzerhandbuch
...................................................................................................................................................................................................
4
Ground the M6x10 grounding stud at Bias-Ts with customer provided grounding system.
Y-Bias-T connector
Route and connect RF jumper cables to the RRH
Use the following procedure to connect the RF jumper cables to the RF ports on top of
the RRH
the RRH
...................................................................................................................................................................................................
1
Label both ends of each cable with receive diversity number.
...................................................................................................................................................................................................
2
Connect the RF jumper cable(s) to the RRH port(s) and route them from the RRH to the
RF antenna.
RF antenna.
...................................................................................................................................................................................................
3
Providing adequate slack, cut each cable so it reaches its corresponding RF antenna
connector or, if applicable, its corresponding RF surge protector.
connector or, if applicable, its corresponding RF surge protector.
Re-mark each RF jumper cable if the cable marking has been removed.
...................................................................................................................................................................................................
4
Terminate the end of each cable with the supplied 7/16 DIN connector. (Use the
appropriate stripping tool. Refer to
appropriate stripping tool. Refer to
for the appropriate tool required for installation).
M6 x 1.0 Grounding stud
M29 x 1.5-6g thread
Antenna port
DC Injection port
(40.0mm)
(20.0mm)
(31.8mm Hex flats)
(81.7mm)
BTS port
Mates to IEC 169-4: 169-1 or equivalent
(41.8mm)
Finish the installation
To route and connect RF jumper cables
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
FDD RRH 700L
3MN-00075-0002-RJZZA
Issue 0
FDD RRH 700L
3MN-00075-0002-RJZZA
Issue 0
September 2012
Alcatel-Lucent – Proprietary
Use pursuant to applicable agreements
7-5
E
N D
O F
S T E P S
...................................................................................................................................................................................................