Nokia of America Corporation BBTRX-06 Benutzerhandbuch
...................................................................................................................................................................................................
5
Connect each RF jumper cable to its corresponding RF antenna cable.
Important! RF surge protectors are optional.
...................................................................................................................................................................................................
6
Torque each 7/16, male DIN connector to 25 Nm (221 in lb), as shown in the figure
below.
below.
Important! When connecting the 7/16, DIN male connector (on the RF jumper cable)
to the 7/16, DIN female connector (on the antenna cable) two wrenches must be used.
The rotating coupling nut on the 7/16, male connector is tightened with a 32 mm end
wrench while the 7/16, male connector on the RF jumper cable is held with a 22 mm
end wrench. Refer to the figure below.
to the 7/16, DIN female connector (on the antenna cable) two wrenches must be used.
The rotating coupling nut on the 7/16, male connector is tightened with a 32 mm end
wrench while the 7/16, male connector on the RF jumper cable is held with a 22 mm
end wrench. Refer to the figure below.
Finish the installation
To route and connect RF jumper cables
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
7-6
Alcatel-Lucent – Proprietary
Use pursuant to applicable agreements
FDD RRH 700L
3MN-00075-0002-RJZZA
Issue 0
September 2012
E
N D
O F
S T E P S
...................................................................................................................................................................................................