E F Johnson Company 2425M70 Benutzerhandbuch
7-15
SMARTNET / SmartZone / P25 Trunked Features
5 To exit this mode, cycle radio power or press and hold the Emergency switch.
7.10
Failsoft Operation
If a failure occurs in the SMARTNET/SmartZone or P25 Trunked system so that it cannot
be used, the system directs the radio to automatically enter the failsoft mode. When in this
mode, “FAILSOFT” is displayed. A failsoft tone may also be heard, depending on how
the repeater is programmed.
be used, the system directs the radio to automatically enter the failsoft mode. When in this
mode, “FAILSOFT” is displayed. A failsoft tone may also be heard, depending on how
the repeater is programmed.
When in the failsoft mode, operation is in the conventional mode on the preprogrammed
failsoft channel (a different failsoft channel can be programmed on each talkgroup). If a
transmission is attempted before a failsoft channel is located, a continuous tones sounds
until the PTT switch is released. When the radio system returns to normal operation, this is
automatically detected and normal operation resumes.
failsoft channel (a different failsoft channel can be programmed on each talkgroup). If a
transmission is attempted before a failsoft channel is located, a continuous tones sounds
until the PTT switch is released. When the radio system returns to normal operation, this is
automatically detected and normal operation resumes.
7.10.1 Programmable Failsoft Connect Tone
On a SMARTNET or SmartZone trunking system(s), a different radio failsoft connect
tone can be programmed. This allows the radio to emit a distinct and different tone for
failsoft than tones used during other operating modes.
tone can be programmed. This allows the radio to emit a distinct and different tone for
failsoft than tones used during other operating modes.
The failsoft connect tone setting will normally be selected to "Default." This means that
the connect tone used during failsoft will be the connect tone setting the system sends over
the air, or the programmed connect tone if no over the air value is received. If it is known
what the connect tone will be during failsoft operation, this can be programmed using the
PCConfigure application. If a value other than "Default" is programmed, the radio will
always use this connect tone setting during failsoft operation.
the connect tone used during failsoft will be the connect tone setting the system sends over
the air, or the programmed connect tone if no over the air value is received. If it is known
what the connect tone will be during failsoft operation, this can be programmed using the
PCConfigure application. If a value other than "Default" is programmed, the radio will
always use this connect tone setting during failsoft operation.
7.11
SMARTNET / SmartZone / P25 Trunked Scanning Features
Scanning on a SMARTNET/Smartzone or P25 Trunked system is called Priority Monitor
Scan. The following are unique features of this type of scanning. For general scanning
information applicable to all operating modes, refer to Sections 5.12 and 5.13.
Scan. The following are unique features of this type of scanning. For general scanning
information applicable to all operating modes, refer to Sections 5.12 and 5.13.
• Scanning is turned ON and OFF by the Scan option switch (or selecting the menu
parameter). Talkgroups (channels) can be programmed so that scanning automatically
starts whenever the talkgroup is selected (Autoscan).
starts whenever the talkgroup is selected (Autoscan).
Draft 4/29/2014