Motorola Solutions Inc. 99FT5029 Benutzerhandbuch
Chapter 4 Electrical Connections
After the MOTOTRBO Repeater has been mechanically installed, electrical connections must be
made. This involves making the following connections:
made. This involves making the following connections:
• AC power cord, and
• antenna coaxial cables
• antenna coaxial cables
shows the position of the various connectors and connections on the rear panel of the
repeater.
Figure 4-1 Locations of Connectors on the Rear Panel of the Repeater
4.1
Power Supply Connections
4.1.1
AC Input Power Connection
NOTE: The AC source must be installed near the equipment and must be easily accessible.
Each repeater ships with a 2.438 m (8 feet) 3-conductor line cord that connects the repeater to a
110/120/220/240 V
AC
repeater. Insert the 3-prong plug into a 110/120/220/240 V
AC
grounded outlet.
If an alternate line cord is required, obtain a suitable line cord, with fittings approved by the safety
testing agency in the end-use country, from a certified electrical parts supplier.
testing agency in the end-use country, from a certified electrical parts supplier.
Do NOT apply AC power to the repeater at this time. Make sure that the circuit
breaker associated with the AC outlet is turned to OFF.
breaker associated with the AC outlet is turned to OFF.
Tx
Rx
GND
POWER
SUPPLY FAN
BATTERY
BACKUP
CONNECTOR
AC LINE CORD CONNECTOR
ETHERNET CONNECTOR
GROUND SCREW
TX CONNECTOR
RX CONNECTOR
POWER SUPPLY ON/OFF SWITCH
REAR
ACCESSORY
CONNECTOR
MAIN FAN
!
C a u t i o n