Motorola Solutions Inc. 99FT5029 사용자 설명서

After the MOTOTRBO Repeater has been mechanically installed, electrical connections must be 
made. This involves making the following connections:

• AC power cord, and
• antenna coaxial cables

 shows the position of the various connectors and connections on the rear panel of the 

repeater.

NOTE: The AC source must be installed near the equipment and must be easily accessible.

Each repeater ships with a 2.438 m (8 feet) 3-conductor line cord that connects the repeater to a 

 

110/120/220/240 V

AC

 shows the location where the AC line cord connects to the 

repeater. Insert the 3-prong plug into a 110/120/220/240 V

AC

 grounded outlet.

If an alternate line cord is required, obtain a suitable line cord, with fittings approved by the safety 
testing agency in the end-use country, from a certified electrical parts supplier. 

Do NOT apply AC power to the repeater at this time. Make sure that the circuit 
breaker associated with the AC outlet is turned to OFF.

Tx 

Rx 

GND