Vital Home Systems LLC VC100 Benutzerhandbuch
P a g e
| 8
© 2015 Vital Home Systems
This install position is NOT recommended and WILL cause battery damage!
Step 5. Attach the VC100 to the Valve – Reassemble the Valve Coupler Mount with the 4 long bolts to
the valve installed on the water line. Ensure valve and the VC100 motor are in the OPEN position.
Reattach the VC100 motor to the Valve Coupler Mount taking care to align the stem Coupler onto the
valve stem. You may have to turn the motor housing a little to get it to line up if the valve was bumped.
Line up the 4 Valve Coupler Mount bolt holes and reattach the 4 large screws to the VC100 base with
the large allen key. Snug these screws in firmly. Toggle the VC100 CLOSED then OPEN to ensure proper
operation.
Step 6. Plugging in Optional Power Supply- Plug the 120V AC to 6V DC adapter into an appropriate NON-
GFE protected circuit and plug the DC cable into the bottom base of the motor. It is recommended to
secure the DC power cord to the water pipe with little slack and a cable tie to ensure the DC plug does
not accidently get pulled out of the VC100.
Programming the VC100 to the 1050 or 1060 Control
Panel
Panel
All
programming of the VC100 valve controller may be done via the 1050 or 1060 Control Panel with
the Vital Home Systems PC software. The software may be downloaded from Vital Home Systems
Website at: http://www.vitalhomesystems.com/#!resources/c9ds
You must register your 1050 or 1060 and VC100 on the Vital Home Systems Website to download the
software.
The Software is written only for Windows version 10 through Vista. Download and install the software
to your Windows Desktop prior to plugging the 1050 USB cable into the computer and the 1050 Control
Panel.
Website at: http://www.vitalhomesystems.com/#!resources/c9ds
You must register your 1050 or 1060 and VC100 on the Vital Home Systems Website to download the
software.
The Software is written only for Windows version 10 through Vista. Download and install the software
to your Windows Desktop prior to plugging the 1050 USB cable into the computer and the 1050 Control
Panel.