Appareo Systems LLC 1505005 Benutzerhandbuch

Seite von 42
600840-000031 Stratus ESG Installation Instructions 
Rev. 1.1 
Last Revised: January 6, 2016 
 
Page 35 of 42 
 
Figure 3: Stratus ESG front panel 
6.1. 
Mode selection keys 
Use the mode selection keys to change the transponder mode. The table below describes each 
of these modes and during what phase of flight each mode should be used. 
Mode 
Key 
Description 
Off 
PWR 
Stratus ESG is powered off. 
Standby 
SBY 
Stratus ESG is powered on and does not send responses to 
any ATC interrogations. 
Altitude 
ALT 
Stratus ESG is powered on and responds to all Mode A/C/S 
interrogations. Altitude is reported. 
Ground 
(none) 
Stratus ESG is powered on and in ALT or On mode, but does 
not report altitude. This mode is automatically detected, but 
ALT or ON keys can override Ground mode. Standby mode 
removes this override. 
On 
ON 
Stratus ESG is powered on and responds to all Mode A/C/S 
interrogations, but altitude reporting is suppressed. 
Table 25: Mode selection keys 
6.2. 
Event indicators 
When certain events occur, an indicator will appear on your Stratus ESG display. The table 
below descri
bes each indicator’s meaning. 
Indicator 
Meaning 
 
ADS-B transmission contains GPS position information with a radius of 
containment under 1 nautical mile. 
 
A response was transmitted from a mode A/C/S interrogation. The indicator 
will time out if another reply does not occur within one second. 
 
A built-in-test (BIT) has failed. See Section 4.19.9 of this document and the 
Stratus ESG 
Pilot’s Guide for more information about BIT failures.