ALVOR ELECTRONICS INC. LIGHT10 Benutzerhandbuch
ALVOR SWITCH WIRELESS
model LUZ 10
with the commands DIMMER and SLEEPY
composed of a SWITCH UNIT and a POWER UNIT
USER MANUAL
‘’This equipment operates in a secondary character, this means, doesn’t have the right to protection against
harmful interference, even from stations of the same kind, and itself can’t cause interference to systems
operating in a primary character”
harmful interference, even from stations of the same kind, and itself can’t cause interference to systems
operating in a primary character”
OPERATION
Your WIRELESS SWITCH was designed to operate like a regular light switch.
When you press the ON side of the SWITCH UNIT’s TOUCH for 1 second and the release it, the lamp will go ON.
When you press the OFF side of the SWITCH UNIT’s TOUCH for 1s and then release it, the lamp will go OFF.
If you keep pressed the ON side of the SWITCH UNIT’s TOUCH, after 5 seconds the lamp will blink once and then
will stay ON for 10 minutes. After that the lamp automatically goes OFF. Since you see the blinking, the TOUCH
should be released, if this is the desired command.
If you keep pressed the ON side of the SWITCH UNIT’s TOUCH, after 10 seconds the lamp will start changing its
luminosity, will start dimming. Then you should release the TOUCH, if this is the desired command. The dimming
cycle will continue automatically, with the luminosity changing every 1 second. The luminosity will go from
almost OFF to BRIGHT and then fading again to almost OFF, continuously. When you see the desired luminosity,
either side of the TOUCH should be pressed again for 1 second, stopping the cycle. The selected luminosity will
be memorized and will be showed until you choose a new luminosity.
Always keep the TOUCH pressed till you see the desired command effectively started.
Other advanced commands are available, as described at section USER’S INTERFACE, below. You don’t need to
know them for regular usage. They are useful during the installation phase.
When you press the ON side of the SWITCH UNIT’s TOUCH for 1 second and the release it, the lamp will go ON.
When you press the OFF side of the SWITCH UNIT’s TOUCH for 1s and then release it, the lamp will go OFF.
If you keep pressed the ON side of the SWITCH UNIT’s TOUCH, after 5 seconds the lamp will blink once and then
will stay ON for 10 minutes. After that the lamp automatically goes OFF. Since you see the blinking, the TOUCH
should be released, if this is the desired command.
If you keep pressed the ON side of the SWITCH UNIT’s TOUCH, after 10 seconds the lamp will start changing its
luminosity, will start dimming. Then you should release the TOUCH, if this is the desired command. The dimming
cycle will continue automatically, with the luminosity changing every 1 second. The luminosity will go from
almost OFF to BRIGHT and then fading again to almost OFF, continuously. When you see the desired luminosity,
either side of the TOUCH should be pressed again for 1 second, stopping the cycle. The selected luminosity will
be memorized and will be showed until you choose a new luminosity.
Always keep the TOUCH pressed till you see the desired command effectively started.
Other advanced commands are available, as described at section USER’S INTERFACE, below. You don’t need to
know them for regular usage. They are useful during the installation phase.
USER INTERFACE
SWITCH UNIT
The SWITCH UNIT is equipped with a unique TOUCH.
The TOUCH is the only way to interact with the SWITCH UNIT, and give access to 1 of the 7 commands available
at the SWITCH UNIT.
at the SWITCH UNIT.