Intel MFS5000SI MFS5000SIB Benutzerhandbuch
Produktcode
MFS5000SIB
2BFunctional Architecture
Intel® Compute Module MFS5000SI TPS
3.1.3.2
Supported and Nonsupported Memory Configurations
The server board design supports up to eight DDR2-533 or DDR2-667 Fully Buffered DIMMs (FBD
memory). Use of identical DIMMs with this server board is recommended. The following tables show the
maximum memory configurations supported using the specified memory technology.
memory). Use of identical DIMMs with this server board is recommended. The following tables show the
maximum memory configurations supported using the specified memory technology.
Table 2. Maximum 8-DIMM System Memory Configuration – x8 Single Rank
DRAM Technology x8 Single
Rank
Maximum Capacity
Mirrored Mode
Maximum Capacity
Non-Mirrored Mode
256 Mb
1 GB
2 GB
512 Mb
2 GB
4 GB
1024 Mb
4 GB
8 GB
2048 Mb
8 GB
16 GB
Table 3. Maximum 8-DIMM System Memory Configuration – x4 Dual Rank
DRAM Technology x4 Dual
Rank
Maximum Capacity Mirrored
Mode
Maximum Capacity
Non-Mirrored Mode
256 Mb
4 GB
8 GB
512 Mb
8 GB
16 GB
1024 Mb
16 GB
32 GB
2048 Mb
16 GB
32 GB
The following configurations are not validated or supported with the Intel
®
Compute Module MFS5000SI:
DDR2 DIMMs that are not fully buffered are NOT supported on this server board.
DDR2-533 memory is not planned to be validated on this product.
Mixing memory type, size, speed, and/or rank is not validated and is not supported.
Mixing memory vendors is not validated and is not supported.
Non-ECC memory is not validated and is not supported in a server environment
DDR2-533 memory is not planned to be validated on this product.
Mixing memory type, size, speed, and/or rank is not validated and is not supported.
Mixing memory vendors is not validated and is not supported.
Non-ECC memory is not validated and is not supported in a server environment
For a complete list of supported memory for the Intel
®
Compute Module MFS5000SI, refer to the Tested
Memory List published in the
3.1.3.3
DIMM Population Rules and Supported DIMM Configurations
DIMM population rules depend on the operating mode of the memory controller, which is determined by
the number of DIMMs installed. DIMMs must be populated in pairs. DIMM pairs are populated in the
following DIMM slot order: A1 and B1, C1 and D1, A2 and B2, C2 and D2. DIMMs within a given pair
must be identical with respect to size, speed, and organization.
the number of DIMMs installed. DIMMs must be populated in pairs. DIMM pairs are populated in the
following DIMM slot order: A1 and B1, C1 and D1, A2 and B2, C2 and D2. DIMMs within a given pair
must be identical with respect to size, speed, and organization.
Intel supported DIMM configurations for this server board are shown in the following table.
Revision 1.4
Intel order number: E15154-007
10