Texas Instruments DLP® LightCrafter™ Evaluation Module DLPLIGHTCRAFTER DLPLIGHTCRAFTER 데이터 시트

제품 코드

DLPLIGHTCRAFTER

www.ti.com

Triggering External Peripherals (Camera and So Forth)

Figure 2-31. DLP LightCrafter GUI Output Trigger Settings

To setup the output Trigger, follow these steps:

1. Check the "Enable" checkbox in the Output Trigger Settings as shown in

Figure 2-32

•

The output trigger can only be enabled if the EVM is in either "Stored Pattern Sequence" mode or
"External Streaming Pattern Sequence" while in "HDMI Port" mode.

Figure 2-32. DLP LightCrafter GUI Output Trigger Enable Checkbox

2. If an active low trigger output is desired, check the "Invert" checkbox. If an active high trigger output is

desired do not check "Invert"

3. Enter the pulse width and delay in microseconds

•

Pulse Width: width of trigger output pulse in microseconds

•

Delay: number of microseconds pulse is delayed after pattern exposure begins

4. Click "Set" as shown in

Figure 2-33

Figure 2-33. DLP LightCrafter GUI Output Trigger Set Button

DLPU006C – January 2012 – Revised December 2013

Operating the DLP LightCrafter

Submit Documentation Feedback