Insys GSM Small 11-02-01-03-02.001 Benutzerhandbuch
Produktcode
11-02-01-03-02.001
28
6. Function Description
6.2 SMS
Dispatch
Example of a text SMS.
AT+CMGF=1
AT+CMGF=1
Set
SMS
text
mode
AT+CSCA=“<Service Center Number>“
SMS service center number
AT+CMGS=”<target number>“
Target
number
>Hello, this is a test<Ctrl Z>
Prompt >, enter SMS text here,
finish text entry with Ctrl Z (0x1A);
the INSYS GSM small starts to
send the SMS message
finish text entry with Ctrl Z (0x1A);
the INSYS GSM small starts to
send the SMS message
Here you have to note that the service center number and the telephone number are
placed in “”.
The service center number must be written in international format, e.g. for a German
provider with „+49“.
After entering the target number (finalize with <CR> ), the prompt for the SMS text >
appears. The text entry has to be completed with <CTRL Z> (not with <CR>!).
6.3 Automatic Execution of AT Commands During Operation
6.3.1 General
The command AT^SCFG offers the possibility to carry out functions time-controlled or
through activating the DTR control line (AT commands).
For time-controlled routines, 3 actions can be configured altogether.
To trigger via DTR, an action can be configured.
For time-controlled functions, the internal timers start from the beginning after a restart
or a reset. This also applies if ATZ or AT&F are entered!
In the following, the most important functions for an application are listed by way of
examples. These examples are also used in the HSComm for GSM small:
through activating the DTR control line (AT commands).
For time-controlled routines, 3 actions can be configured altogether.
To trigger via DTR, an action can be configured.
For time-controlled functions, the internal timers start from the beginning after a restart
or a reset. This also applies if ATZ or AT&F are entered!
In the following, the most important functions for an application are listed by way of
examples. These examples are also used in the HSComm for GSM small:
-
Automatic PIN input/registering after restart
-
Automatic reset
-
Alarm signal via DTR control line
When all functions in the configuration software HSComm are configured, then all
storage locations are in use.
Attention!
The settings of this command are only stored with the command AT^SMSO.
Version 1.00 / 09.04