Juniper Networks T1600 Benutzerhandbuch
Installing a T1600-SIB
Each SIB weighs approximately 6.5 lb (3 kg). To install a T1600-SIB, follow this
procedure (see Figure 20 on page 32):
procedure (see Figure 20 on page 32):
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis. See “Preventing
Electrostatic Discharge Damage” on page 47.
connect the strap to one of the ESD points on the chassis. See “Preventing
Electrostatic Discharge Damage” on page 47.
2.
Place one hand underneath the T1600-SIB to support it. With the other hand,
hold one of the ejector handles on the T1600-SIB faceplate.
hold one of the ejector handles on the T1600-SIB faceplate.
3.
Carefully align the sides of the T1600-SIB with the guides inside the chassis.
4.
Slide the T1600-SIB into the chassis, carefully ensuring that it is correctly aligned.
5.
Grasp both ejector handles and press them inward to seat the T1600-SIB. Ensure
that the ejector handle tabs are properly mated inside their corresponding chassis
slots. You might have to close and open the handles a few times before the tabs
catch the slots.
that the ejector handle tabs are properly mated inside their corresponding chassis
slots. You might have to close and open the handles a few times before the tabs
catch the slots.
6.
Tighten the captive screws on the ejector handles.
7.
Bring the T1600-SIB online using one of the following methods:
■
Press and hold the
ONLINE/OFFLINE
button on the T1600-SIB faceplate. The
green
OK
LED on the faceplate begins to blink. Hold the button down until
the LED blinks.
■
Issue the following CLI command on the routing node:
user@host> request chassis sib online slot 0
Figure 20: Installing a T1600-SIB in a T1600
g002406
32
■
Upgrading SIBs
T1600 Routing Node Upgrade Guide