Fairchild CAM/CMOS-2K.LS Benutzerhandbuch
Table 2.2.1
Camera Pin #
Frame Grabber Pin #
Channel Link Signal
1 1 Inner
shield
14 14 Inner
shield
2 25
X0
15 12
X0+
3 24.0
X1-
16 11
X1+
4 23
X2-
17 10
X2+
5 22
Xclk
18 9
Xclk+
6 21
X3
19 8
X3+
7 20 SerTC+
20 7
SerTC-
8 19 SerTFG-
21 6 SerTFG+
9 18
CC1-
22 5
CC1+
10 17
CC2-
23 4
CC2+
11 16
CC3-
24 3
CC3+
12 15
CC4-
25 2
CC4+
13 13 Inner
shield
26 26 Inner
shield
Notes:
• Exterior overshield is connected to the shells of the connectors on both ends.
• Exterior overshield is connected to the shells of the connectors on both ends.
• 3M part 14X26-SZLB-XXX-0LC is a complete cable assembly, including connectors.
• Unused pairs should be terminated in 100 ohms at both ends of the cable.
2.3 Power Supply
• The camera uses a single voltage input, normally set to 5.0V.
• Ripple and noise is required to be < 20 mV RMS.
• Power is supplied through a Hirose connector.
• When installing the mating connector, be sure to line up the slots. This action will assure that
• Ripple and noise is required to be < 20 mV RMS.
• Power is supplied through a Hirose connector.
• When installing the mating connector, be sure to line up the slots. This action will assure that
you will not bend any of the pins.
Fairchild Imaging • CAM/CMOS-2K.LS Line Scan Camera User’s Manual • Rev C• 12 of 42