Fairchild CAM/CMOS-2K.LS Benutzerhandbuch

 

Follow your Frame Grabber manufacturer’s instructions when inserting the frame grabber card into 
your PC.  Be sure that you install the correct configuration software that matches the camera that 
you are using. 

At this point your camera should already be connected to the DC power supply, and connected to 
the frame grabber in your PC.  Your frame grabber will see our camera and start communicating 
almost immediately.  As soon as your camera starts communicating with the frame grabber, you 
can verify this fact by looking at your monitor and observing the video signal. 

To communicate with your camera we have created specific commands.  In the next section we will 
go over these commands in detail. 

 

Note:  Commands are not case sensitive.  To input commands, type in the three character 
command and hit enter. 

Command + enter, example:  Type in RSH, then enter 

Command + enter + value, example:  Type in SSM then enter, then type 2 

Command + enter + value + enter, example:  Type in SLR then enter, then type 2000, then enter 

This command allows you to perform a hard camera reboot. 

The camera returns….………..…Reboot Started 

This command allows you to perform a logic reset. 

No return………………………….no message 

This command will show you what camera is connected to your PC. 

The camera returns…..………….Fairchild Imaging 2K CMOS 

Fairchild Imaging • CAM/CMOS-2K.LS Line Scan Camera User’s Manual • Rev C• 14 of 42