ArtDio IPE 1000 Benutzerhandbuch

PBX GATEWAY#configure

Enter configuration commands, one per line. End with CTRL/Z

PBX GATEWAY (config)#

Step 3: Assign the IP address and the subnet mask

Command: PBX GATEWAY (config)#ip address <ip-address> <subnet-mask>

PBX GATEWAY (config)#ip address 203.79.238.144 255.255.255.128

System must then be restarted

PBX GATEWAY (config)#

Step 4: Assign the default gateway

Command: PBX GATEWAY (config)#ip default-gateway <address>

PBX GATEWAY (config)#ip default-gateway 203.79.238.186

PBX GATEWAY (config)#

Step 5: Save the configuration to non-volatile memory immediately. If you power the device off

immediately, your new configurations will be lost when you switch the power off. However, the system

will automatically save the configuration if no input has been detected within one minute.

PBX GATEWAY (config)#dbflush

PBX GATEWAY (config)#

Step 6: Switch back to privileged mode

PBX GATEWAY (config)#exit

PBX GATEWAY#

Step 7: You must now restart the system in order for your changes to take effect. After the restart

command is issued, the system will prompt for a confirmation.

PBX GATEWAY#restart

This command resets the system. System will restart operation code agent.

Reset system, [Y]es or [N]o? Yes