ArtDio IPE 1000 Benutzerhandbuch

 

 27

                                                     

PBX GATEWAY (config)# 

 

Step 3: Enable DHCP Mode 

PBX GATEWAY (config)#ip state dhcp 

PBX GATEWAY (config)# 

 

Step 4: Back to Privileged Mode 

PBX GATEWAY (config)#exit 

PBX GATEWAY# 

 

Step 5: Restart the system to enable DHCP mode. After the restart command is issued, the system 

will prompt for a confirmation.  

 

PBX GATEWAY#restart 

This command restarts the system.  The system will now restart operation code 

agent. 

Reset system, [Y]es or [N]o? Yes 

 

Using Phone Set Interface (please refer to the Phone Set Interface Configuration Procedures for 

more detailed information) 

 

Step 1: Take the handset off the phone. Step 2: After hearing the dial tone dial the PROG Access 

Code. 

Step 3: Enter the Password.

2

Step 4: Enter code "01" to begin configuring the DHCP state. 

Step 5: Enter  "1" to enable DHCP client and "#" as the ending prompt. You will then hear the 

confirmation tone. (Or enter  "0" to disable the DHCP client and "#" as the ending prompt). 

Step 6: Enter code "98" then press "1" and "#" as the ending prompt. You will then hear 

the confirmation tone, the system will then restart automatically. 

 

Place the handset on the phone to end your configuration session.

 

2

 The  (default) password for the Phone Set Interface is "0000".