Baumatic BC391.3TCSS Benutzerhandbuch
30
o
If the cooker has been converted for use with LPG, then it should
and or stripe.
o
Gas pressure may be checked on a semi-rapid hob burner.
Remove the appropriate injector and attach a test nipple. Light
Remove the appropriate injector and attach a test nipple. Light
re complies
with the gas standards in force.
as adjustment (Conversion to LPG for the hob top)
cooker from the electricity
jectors and/or adjusting the
o
Remove the pan-stands,
burners and flame spreaders.
burners and flame spreaders.
o
A straight female to female equal black connector must then be
attached. The approved flexible connection should be made to
this.
attached. The approved flexible connection should be made to
this.
be connected to the gas supply using an appropriate bayonet
type hose. The hose MUST be suitable for use with LPG gas,
these are identifiable by a red b
type hose. The hose MUST be suitable for use with LPG gas,
these are identifiable by a red b
o
A hose length of 0.9m to 1.25m is recommended. The length of
hose chosen should be such that when the cooker is in situ, the
hose does not touch the floor.
hose chosen should be such that when the cooker is in situ, the
hose does not touch the floor.
o
Care should be taken to ensure that the temperature rise of
areas at the rear of the cooker that are likely to come in contact
with the flexible hose do not exceed 70°C.
areas at the rear of the cooker that are likely to come in contact
with the flexible hose do not exceed 70°C.
the other burners and observe that the gas pressu
G
All work must be carried out by a GASSAFE registered
engineer.
IMPORTANT: Always isolate the
supply before changing the in
minimum flow of the burners
supply before changing the in
minimum flow of the burners
.