Barco Projector 26-0313000-00 Benutzerhandbuch

Programming EDID

Encore system setup:  Step 5 

The EDID (Extended Display Identification Data) programming procedure is a prerequisite 
for background and DSK setup.  The procedure guarantees proper communications at the 
preferred resolution between Encore’s DVI inputs and your system’s PCs.

S

 — Ensure that you are familiar with the EDID DVI Input Format 

.  In Chapter 5, refer to the “

” section on 

„

Use the following steps to program Encore’s EDID:

Ensure that Encore’s output format matches your projector’s native resolution.  In 
Chapter 5, refer to the “

” section on page 160 for details.

Ensure that the computer(s) that you wish to use as background and DSK 
source(s) are capable of supporting the selected output resolution.

Ensure that all DVI inputs to each Video Processor are disconnected.

In the System Keypad, press MISC to access the Miscellaneous Menu.

Press {EDID} to display the EDID DVI Input Format Menu.

On the Destination line, select the individual destination whose EDID you wish to 
program, or select ALL if all destinations will be using the same resolution.

Note the Current EDID format line, which displays the EDID format that resides 
in memory.  If this format is already set to the desired resolution, no programming 
is required.  You can exit this procedure, and continue with the next setup step.

If a new resolution is required, scroll to the Format line and use the ADJ knob to 
select the preferred EDID format.  

Press {PROGRAM EDID} to display a warning message.  Press {CONTINUE} to 
continue with the procedure.

Once EDID programming is complete, reconnect each external computer and 
power it back on.  

On each PC’s desktop, right-click to display the Display Properties Window.  

Select the Settings Tab, and verify that the PC’s resolution matches that which 
you just programmed into EDID.  If not, set the resolution as required.

Repeat steps 6 through 12 for each additional Encore destination.

5