Barco Projector 26-0313000-00 Benutzerhandbuch

Seite von 432
394
Encore Presentation System  •  User’s Guide  •  Rev 04
aK==tçêâáåÖ=táíÜ=aÉëíáå~íáçåë
ScreenPRO-II Configurations
fåíÉêå~ä=oçìíÉê=`çåÑáÖìê~íáçå
The diagram below illustrates an Encore configuration that uses two ScreenPRO-II units 
with internal source routing.  Each ScreenPRO-II is set up as a unique destination.
Figure D-1.  ScreenPRO-II units using internal source routing
For an “internal routing” ScreenPRO-II configuration, please note the following points 
regarding destination setup and source connections:
On the Destination Setup Menu:
~
Select Single Screen SP as the “Type.”
~
Set the “Routing Mode” to Internal.  
~
In Chapter 6, refer to the “
page 279 for instructions.
Connect analog and digital sources directly to each ScreenPRO-II. 
ScreenPRO-II inputs are mapped using the Input Patch Menu:   
~
If you are using D/As to connect sources to similar inputs on each 
ScreenPRO-II, select ALL SP as the “Connection Type.”
~
If you are connecting to different inputs, separate input patches are 
required for each.  
~
In Chapter 6, refer to the “
” section on page 285 
for instructions.
Encore Controller (SC or LC)
ScreenPRO-II
Analog Inputs 1-8
HD/SD Inputs 1-2 
(HD Model Only)
Analog Inputs 1-8
HD/SD Inputs 1-2 
(HD Model Only)
Internal Routing
Ethernet Switch
Side Screen 1
Side Screen 2