Barco Projector 26-0313000-00 Benutzerhandbuch

ScreenPRO-II Configurations

The diagram below shows a configuration that uses two ScreenPRO-II units with external 
source routing.  Each ScreenPRO-II is set up as a unique destination.  Two external 
Ethernet routers are used — one for analog connections and one for SDI source 
connections to each ScreenPRO-II.  

Figure D-3.  ScreenPRO-II units using external Ethernet controlled routers

For an “external routing” configuration with Ethernet controlled routers, please note the 
following points regarding destination setup and source connections:

On the Destination Setup Menu:

Select Single Screen SP as the “Type.”

Set the “Routing Mode” to External.  

In Chapter 6, refer to the “

page 279 for instructions.

Connect analog and digital sources to each router in the normal manner. 

For each router, connect two outputs to each ScreenPRO-II.

On the Router Specification Menu, select the correct router and manufacturer, 
and set the “Communication Type” to ETHERNET.  In Chapter 6, refer to the 
“

” section on page 270 for instructions.

Router outputs are mapped using the Output Patch Menu.  This menu defines 
which router output connects to which ScreenPRO-II input.  In Chapter 6, refer to 
the “

” section on page 270 for instructions.  

Router inputs are mapped using the Input Patch Menu.  In Chapter 6, refer to the 
“

” section on page 285 for instructions.

MatrixPRO SDI Router

MatrixPRO Analog Router

Encore Controller (SC or LC)

ScreenPRO-II

Ethernet Switch

Side Screen 1

Side Screen 2

Router

Outputs

Inputs

SDI 

Inputs

Analog 

Inputs